Using MIP Monitor software, to reset the device to the factory defaults:

  • Establish communication as normal with the sensor.
  • Click Settings.
  • Click Load Default Settings and a message box pops up.
  • Click OK and the message box disappears.
  • Click Settings again.
  • Click Save Current Settings and a message box pops up.
  • Click OK and the message box disappears.

This process does not erase any hard and soft iron calibration that may be on the device.

The Hard and Soft Iron Cal software we provide must be used to do that.

 

Yes.  We have had good success with several types of off-the-shelf USB to serial port adaptors, such as those from IOGear and Keyspan, which may be purchased through any of the electronics products distributors.

 

Not what you're looking for? Visit our FAQ page or contact our Sales team.